1buycart 5 Set 3D Printer Stepper Motor Driver 2.5A 256 Subdivisions Board with Heat Sink 5.5‑38V
Mô tả ngắn
Máy Tính & Laptop > Máy In, Máy Scan & Máy Chiếu > Máy In 3D > 1buycart 5 Set 3D Printer Stepper Motor Driver 2.5A 256 Subdivisions Board with Heat Sink 5.5‑38V
- Giao hàng toàn quốc
- Được kiểm tra hàng
- Thanh toán khi nhận hàng
- Chất lượng, Uy tín
- 7 ngày đổi trả dễ dàng
- Hỗ trợ xuất hóa đơn đỏ
Sản phẩm tương tự
Giới thiệu 1buycart 5 Set 3D Printer Stepper Motor Driver 2.5A 256 Subdivisions Board with Heat Sink 5.5‑38V
✌ large-scale Discount Voucher Code！！Enter a discount code to buy more offers！✍☚ All ready stock !! ☛=
☜ High quality product ☝
☟ Good packaging ✌
We will arrange 24 hours shipping asap！Fast delivery (from China) 5 to 12 business days after shipment(except some special holidays).
♔ ♕ ♖ ☻
Feature:
1. No Noise: This stepper motor driver continues the characteristics of TMC series drivers, and has a good mute effect.
2. 256 Subdivisions: The chip of the driver is expanded to 256 subdivisions internally, with better performance.
3. Large Current: The drive current is larger, the maximum peak current is up to 2.5A, and the stable printing current is up to 1.7A.
4. Good Heat Dissipation: This stepper motor driver has lower heating efficiency and better heat dissipation than other TMC series drives.
5. Support UART Mode: The driver supports UART mode and is applicable to for MKS SGEN L without jumper.
Specification:
Item Type: 3D Printer Stepper Motor Driver
Material: Aluminum alloy
Output Current: 2A
Recommended Working Current: 1.7A
Microstep: 256 microstep subdivision
Configuration: STEP DIR OR UART
Load Driving Voltage Range: 5.5-38V
IC Logic Working Voltage: 3V, 5V
Package List:
5 x 3D Printer Stepper Motor Driver5 x Heat Sink
How to Use
1. Pay special attention to the driving direction, and do not plug it reversely.
2. Do not connect the motor when measuring the voltage, or it will burn out.
3. When measuring the voltage, connect the power supply, not just USB power supply.
4. When using on the printer control board, please keep 3 jumper caps under the socket.
5. Before adjusting the knob, it must be carried out under the condition of power off. After the adjustment is completed, the power on measurement shall be carried out to prevent the drive or main board from burning out.
6. When pasting the heat sink, please pay attention to the distance between the heat sink and the pin, or it will cause a short circuit between the heat sink and the leading angle.
7. In case of operation, please do a good job in heat dissipation (heat sink and cooling fan) to prevent the abnormal operation of the drive overheating.
Hình ảnh sản phẩm
Giá FAR