Bảng Mạch Thay Thế Ziqucu CH32V103C8T6 RISC-V MCU Cho Arduino STM32F103C8T6 Core

Giới thiệu Bảng Mạch Thay Thế Ziqucu CH32V103C8T6 RISC-V MCU Cho Arduino STM32F103C8T6 Core

Features:
1.CH32V103 series is a 32-bit general-purpose microcontroller with RISC-V3A processor as its core,
2.The processor is designed based on RISC-V open source instruction set. It integrates clock security mechanism, multi-level power management and general DMA controller.
3.This series has rich peripheral resources such as one USB2.0 host/device interface, multi-channel 12-bit ADC conversion module, multi-channel TouchKey, multiple sets of timers, multi-channel IIC USART SPI interface, etc.
4.The microcontroller is equipped with a complete software and hardware platform and debugging interface tools, which can meet various needs in the industrial, medical, consumer and other markets, and is widely used in: motor drive and application control
5.Application fields: widely used in motor drive and application control, PC game peripherals and GPS platforms, programmable controllers, frequency converters, printers, scanners, alarm systems, video intercoms, heating, ventilation and air conditioning systems and other occasions.

Parameters:
RISC-V3A processor, up to 80MHz system dominant frequency
Support single-cycle multiplication and hardware division
20KB SRAM ,60KB CodeFlash
Power supply range: 2.7-5.5V, GPIO synchronous power supply voltage
Multiple low efficiency modes: sleep/stop/standby
Power-on and power-off reset (POR/PDR)
Programmable Voltage Monitor (PVD)
7-channel DMA controller
16-way TouchKey channel detection
16-channel 12-bit ADC conversion channel
7 timers
1 USB2.0 host/device interface (full speed and low speed)
2 IIC interfaces (supporting SMBus/PMBus)
3 USART interfaces
2 SPI interfaces (support Master and Slave modes)
37 I/O ports, all of which can be mapped to 16 external interrupts
CRC computing unit, 96-bit chip uniquelD
Serial single line debugging (SWD) interface
Board size: 35.5mm * 52.5mm
Commissioning burning instructions:
Using the MounRiver compiler, you can choose to use USB cable or serial port, independent WCH-Link for simulation and download
Unprotection instructions: press and hold the BOOT key, press the RST key again, and then release the BOOT0 key after one second
USB:
R9/R11 can be used to download programs
R10/R12 can be selected by pad
Serial port pins are PA9 (TX), PA10 (RX)
1. Query chip read protection status;
2. To set the chip read protection, the power-on configuration takes effect again;
3. To remove the chip read protection, the power-on configuration takes effect again;
software development
PUB folder: provides the description of the evaluation board and the schematic diagram of the evaluation board.
EXAM folder: provides the software development drivers and corresponding examples of the CH32V103 controller, classified by peripheral devices. Each type of peripheral folder contains one or more function application routine folders.
Package include：
1X module
3X pin arrangement

Hình ảnh sản phẩm

Giá MPAA